Cookies help us deliver our services. By using our services, you agree to our use of cookies. More information

Difference between revisions of "Layout for DatLab graphs"

From Bioblast
Line 15: Line 15:




== Reference Layouts: O2k-Core ==
== Reference Layouts: O2k-FluoRespirometer ==
ย  Version: DatLab 7
ย  Version: DatLab 7



Revision as of 10:34, 5 January 2018


high-resolution terminology - matching measurements at high-resolution


Layout for DatLab graphs

Description

A Layout in DatLab is a predefined selection of Plots to be displayed at specific scalings and in a specific order. Any defined graph layout can be selected from the Layout menu for defining initial settings for the plots [Ctrl+F6] and scaling [F6]. A layout can be modified and saved under a specific name. In typical standard DatLab graph layouts plots are shown for the left chamber in Graph 1 (top), and for the right chamber in Graph 2 (below). During data acquisition, a 30 min time range is frequently used and can be adjusted any time during the experiment [F6].


Reference: MiPNet19.18C DatLab-guide

Graph-menu.png
Layout-menu.png

MitoPedia O2k and high-resolution respirometry: DatLab 

Tabs

ยป Plots
ยป Scaling
ยป Info


Reference Layouts: O2k-FluoRespirometer

Version: DatLab 7

Summary

01 Calibration show Temp
02 Calibration - Background
03 Background high O2
----
04a Flux per volume
04b Flux per volume overlay
----
05a Specific flux
05b Specific flux overlay
06a Specific flux high O2
06b Specific flux high O2 overlay
----
07a Flux Control Ratios
07b Flux Control Ratios overlay

01 Calibration show Temp

General information
Layouts 1 ff. are considered for O2k-Core applications.
Layouts Amp* or pX* are selected for O2k-MultiSensor applications.
1 Calibration show temp shows O2 concentration and the negative slope in Graph 1 and 2, and temperature and Peltier power in Graph 3: This is the default layout used after switching on the O2k.
Graph 1 & 2: O2 concentration (blue lines, left Y-axis) and O2 slope neg. (uncorrected; red lines, right Y-axis) are displayed, in the top graph for the left chamber (A), and below for the right chamber (B).
Graph 3: The third graph (bottom) shows the block temperature on the left Y axis (red) and the Peltier power on the right Y axis (green). Only when both temperature and Peltier power are constant, the chambers have reached thermal equilibrium.
  1. During this phase a stirrer test can be performed [F9].
  2. The next step is to observe equilibration of the oxygen signal with a defined gas phase above the stirred aqueous phase ('open') chamber; usually with air as the first step to perform an oxygen sensor calibration.
ยป O2k-Manual: MiPNet19.18A_O2k-start


Reference Layouts: O2 & Amp

Version: DatLab 7
01 Amp Amperometric_Raw signal
02 Amp Amperometric_Calibrated


Reference Layouts: O2 & pX

Version: DatLab 7
01 Potentiometric
----
02a TPP_calibration
02b TPP_with_O2flux
02c TPP_calibrated_with_O2flux


Reference Layouts: Other

Version: DatLab 7
O2 raw signal